UPDATE, okay so not i'm working on splicing the rear quarter panel to prep it for printing. but i have been tasked with making each piece easier to print... as of right now each piece that i print is well over 2 hours, which is unacceptable. so i'm optimizing the pieces and slicing/sizing to lower the printing time and the use of filament, this may take a little while to do , also i'm trying to figure out a way so that they need less maintenance after printing for support. the panels that i have already printed are not staying together very well with just tape. go figure... anyways i need a good solution to make the pieces hold together better. until i get the fiberglass to skin them. my available funds for that project have gone to paying bills. so it might be a little bit until i can get some... feel free to hook me up with some donations if you want :D